Notice: Undefined variable: position6 in /home/domains2/public_html/george-lucas.com/show.php on line 114

Guide :Home Security : Security Simon 3 Wireless Home Security System

Can't add sensor

I've got a Simon 3. I open the panel, punch in my code, press add and once I press sensor, it says "option not available." Ok, start over. Open panel, try to punch in dealer code, nothing works. 123,1234,12345, 123456, 654321, 65432, 6543, 654 all do not work. How can I access the programming menu to add a new sensor? The installation manual doesn't say anything.

Research, Knowledge and Information :



Notice: Undefined variable: go_page in /home/domains2/public_html/george-lucas.com/show.php on line 182

Can't add an extra sensor - iSmartAlarm


Hi, I am setting up the alarm for the first time. I got the basic set with 2 sensors, 2 remotes and one motion detector. I bought an extra sensor to get 3 in total.
Read More At : www.ismartalarm.com...

Can't add motion sensor to room - SmartThings Community


So what has been happening is that when I try to add a motion sensor to a specific room of mine, it does not appear on the list of items I can add. Also- when I try ...
Read More At : community.smartthings.com...

I can’t add Dell PowerEdge sensors to PRTG. What can I do ...


(1) Could not find any disk on this device. (code: PE188) This means that there is no response from the target device. Please check the following:
Read More At : kb.paessler.com...

Can’t Add Iris sensor - Securifi


I’ve tried adding an Iris door/window sensor to the Almond+ by going to “Add Sensor” and tapping on “Add”. The process gets to the point of “Gathering ...
Read More At : forum.securifi.com...

PRTG Manual: Add a Sensor - Paessler


PRTG Manual: Add a Sensor. Content Previous Next. ... Then an assistant will appear, leading you through two steps. For a faster setup, you can select Add Sensor ...
Read More At : www.paessler.com...

Can't add sensor to My Backyard Weather | AcuRite Customer ...


Thanks for the reply. Page 14 states that "you can add sensors back later, if desired." As stated previously, I cannot add sensors back, as there is no green plus ...
Read More At : support.acurite.com...

Monoprice motion sensor - can't add or remove? - Securifi


Well, first of all I think you removed it wrong, as I presume you did it in Connected Home, tap on sensor, edit, remove, but maybe I'm mistaken.
Read More At : forum.securifi.com...

Can't add channel in a sensor/actuator on Raspberry Pi model ...


I am using Raspberry Pi 3 Model B, using Jessie and have same problem with @gopal.amlekar 'Channel' is shown disabled when I trying add distance sensor.
Read More At : community.mydevices.com...

Notice: Undefined variable: position4 in /home/domains2/public_html/george-lucas.com/show.php on line 230

Loading ...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Notice: Undefined variable: position5 in /home/domains2/public_html/george-lucas.com/show.php on line 283
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.george-lucas.com || Terms of Use || Contact || Privacy Policy
Load time: 0.0137 seconds